Remove from group does not work

Article needs peer review

Symptom Removing an object from a  group via the 'remove from group' command does not work.The object stays in the group.

Cause You are selecting the object in a mode that is different from what was used to originally make the object/s a part of the group.

Solution

The selection mode used to add an object/s to the group should be used to remove the object/s from the group too.
e.g: If the object is branch selected (middlemouse selected) and added to the group. Use the branch selection mode to remove the object from the group.



Applies To: XSI 3.5.x on NT,Win2K,Linux

Posted: 12/23/2003

This page was last modified 18:04, 8 Dec 2010.
This page has been accessed 181392 times.

© Copyright 2009 Autodesk Inc. All Rights Reserved. Privacy Policy | Legal Notices and Trademarks | Report Piracy